How to remove the front bumper
- open the hood.
- unscrew two bolts and remove the pads under the headlights.
- at the edges of the front part, we remove the decorative grilles (they are held on latches).
- under the grilles, we unscrew two long bolts (twisted from the bottom up) that attach the amplifier to the brackets. If these bolts are broken and do not unscrew, you can unscrew the six bolts (indicated in the diagram by blue arrows) and remove the bumper along with the brackets.
- in the wheel arches, we screw in the screws (if any) that attach the fenders to the bumper.
- we release the latches in the wings (pull the corners down and towards ourselves, you need to make quite a lot of effort), then lift them up.
- with an assistant, we pull off the bumper in front.
How to remove the rear bumper
- open the trunk lid.
- lift the trunk floor.
- we unscrew the four bolts (twisted from top to bottom) that attach the brackets to the spars. Attention! If you have a tow bar, then there may be six bolts.
If these bolts are torn off and do not unscrew, you can unscrew four bolts (indicated in the diagram by blue arrows) and remove the bumper without brackets (this is very inconvenient , but possible.
- in the wheel arches, unscrew the screws that secure the fenders (if any).
- we release the latches in the wings (pull the corners down and towards ourselves, you need to make quite a lot of effort), then lift them up.
- with an assistant, we gently pull the bumper back.
Audi A6 (S6) first generation C4
Production 1994-1997
Body type:
4-door sedan
5-door Avant
Plastic bumpers:
Polypropylene modified with rubber, 20% mineral filler. Marking >EMPP-TV20<
Or
Polypropylene. Marking >PP <