How to remove the front bumper
- open the hood.
- remove the hood lock lever (you need to pull out the lock with a flat screwdriver and pull the lever up).
- release from the latches and remove the lining above the radiator grille (pull up).
- under the trim, unscrew the two screws (twisted from top to bottom) that secure the upper part of the front bumper.
- on the bottom side, unscrew the screws (twisted from the bottom up) that secure the lower part.
- turn the wheels to the side.
- we release the wheel arch extensions (they are held on the latches, we pull them up from the bottom).
- in the wheel arches, we unscrew five screws on each side, which fasten the fenders (front part) and sides.
- release the latches in the wings (pull the corners towards you). If you are afraid of breaking it, then unscrew two nuts on each side (indicated by blue arrows) and remove them together with the fasteners in the wings.
- with an assistant, we pull the bumper in front (we look at the wires).
- disconnect the connectors of electrical equipment.
How to remove the rear bumper
- open the trunk lid.
- we remove the rear and release the sides of the side linings of the trunk.
- we unscrew four nuts from the trunk (you will need a long cap head of 10 mm)
- on the bottom side, we unscrew the four screws (twisted from bottom to top) that secure the lower part of the rear bumper.
- we release the wheel arch extensions (they are held on the latches, we pull them up from the bottom).
- in the wheel arches, we unscrew four screws on each side, which fasten the fenders (rear part) and sides.
- release the latches in the wings (pull the corners towards you).
- we release the latches under the rear lights (for convenience, the lights can be removed).
- with an assistant, we gently pull the bumper back (we look at the wires).
- disconnect the connectors of parking sensors and other electrical equipment.
Audi Q2 first generation
Production 2016-present
Model years 2017-present
Body Type: 5-door SUV
Plastic bumpers:
A mixture of polypropylene and a triple copolymer of ethylene, propylene and diene, 10% mineral filler. Marking >PP/EPDM T10<