Depending on the year of manufacture, the mounting points may vary slightly.
How to remove the front bumper
- open the hood.
- remove the hood lock lever (you need to press the latch and pull up).
- we pull out five pistons and remove the plastic lining above the radiator grille (two pistons are hidden under the overlays above the headlights, which can simply be bent).
- under the trim, we unscrew the three screws (twisted from top to bottom) that secure the upper part of the front bumper.
- on the bottom side, we unscrew seven screws (twisted from the bottom up), which fasten the lower part (plastic panel).
- we turn the wheels to the side (it will be more convenient if the wheels are removed).
- in the wheel arches, we unscrew five screws on each side, which fasten the left and right fender (front part).
- we release the arch extensions (the front part, you need to pull it from the bottom up, they are held on the retainers).
- under the arch extensions, we unscrew four screws on each side, which fasten the sides.
- release the latches in the wings (pull the corners towards you, if they do not come out, release the bracket nuts one turn).
- with an assistant, we remove the bumper in front (we look so as not to break the wires and hose of the camera washer).
- disconnect the connectors of electrical equipment.
- disconnect the washer hose (if any).
How to remove the rear bumper
- open the trunk lid.
- on the bottom side, we unscrew the eight screws (twisted from bottom to top) that secure the lower part of the rear bumper.
- we release the arch extensions (the back part, pull it up from the bottom).
- in the wheel arches, we unscrew two screws on each side, which fasten the fenders (rear part).
- we unscrew two screws under the arch extensions and one behind the fenders that secure the sides.
- release the latches in the wings (pull the corners towards you).
- with the assistant, we carefully remove the bumper back (we look behind the wires).
- on the left side of the movement path, in the side trim, open the cover and disconnect the common electrical equipment connector under it.
- we release the wiring harness from the body.
Audi Q7 is the second generation. Type 4M
Production 2015-present
Model years 2016-present
Body type:
5-door SUV
Plastic bumpers:
A mixture of polypropylene and a triple copolymer of ethylene, propylene and diene, 20% mineral filler. Marking >PP/EPDM-TV20<