Depending on the year of manufacture, the mounting points may vary slightly.
How to remove the front bumper
- open the hood.
- under the hood, we pull out six pistons and remove the plastic cover.
- under the cover plate, we unscrew the six screws (twisted from top to bottom) that secure the upper part of the front bumper.
- we unscrew four (six) screws from the bottom side (twisted from the bottom up).
- turn the wheels to the side.
- in the wheel arches, we unscrew three screws on each side, which fasten the fenders (front part).
- we move the fenders to the side and unscrew two nuts on each side, in the inner part of the wings.
- (if any) unscrew one screw on each side, which fix the corners to the wings.
- release the latches in the wings (pull the corners towards you).
- with an assistant, we remove the bumper in front (we look so as not to break the wires and hoses).
- disconnect the electrical equipment connectors (if any).
- disconnect the headlight washer hoses (liquid may leak, you should prepare a plug or container).
How to remove the rear bumper
- open the trunk lid.
- remove the plastic linings near the rear lights (they are held on latches).
- under the pads, we unscrew two screws on each side (twisted from top to bottom), which fasten the upper part of the rear bumper.
- on the bottom side, we unscrew two screws (twisted from the bottom up), which fasten the lower part.
- in the wheel arches, we unscrew five screws on each side, which fasten the fenders (rear part).
- we move the slats to the side and unscrew two screws on each side (twisted from the bottom up, they are not very convenient to get to).
- release the latches in the wings (pull the corners towards you).
- with the assistant, we carefully remove the bumper back (we look behind the wires).
- we release the connectors of electrical equipment (if any)..
Audi TT first generation, Type 8N
Production 1998-2006
Body type:
2-door compartment
Plastic bumpers:
A mixture of polypropylene and a triple copolymer of ethylene, propylene and diene, 20% mineral filler. Marking >PP/EPDM TV20<