How to remove the front bumper

- open the hood.

- we unscrew two screws and remove the radiator grille up.

- under the radiator grille, unscrew one screw (twisted from top to bottom).

- remove decorative overlays on the edges of the front part.

- behind the pads, we unscrew two screws (twisted from bottom to top, hexagon 6mm).

- unscrew the wheels to the left or right, depending on which side of the bumper you will unscrew first.

- unscrew the screws securing the fenders (front part).

- we pull the edges of the bumper from the side locks (we pull the edge of the bumper down and towards ourselves).

- with an assistant, we pull the front bumper forward (we look for wires and hoses).

- disconnect the fog lamp connectors and headlight washer hoses (if any).

 

How to remove the rear bumper

- open the trunk lid.

- unscrew the screws and remove the back panel trim.

- behind the trim, we unscrew four nuts (13 mm) that attach the brackets to the body.

- through the hole, unscrew one screw (twisted from top to bottom).

- in the wheel arches, unscrew the screws that secure the sides (if any).

- we pull off the corners from the side locks (we pull the edge of the bumper down and towards ourselves).

- we pull out the bumper on ourselves (it is advisable to do this together, so as not to scratch the paint on the wings).

Audi 80 (Audi 90) B3 (89)

Production 1986-1992

Body type:

4-door sedan

Plastic of bumpers: polypropylene, marking >PP<