Depending on the year of manufacture and body type, the mounting points differ slightly.

How to remove the front bumper

- open the hood.

- under the hood, we unscrew the three screws that secure the upper part of the front bumper (radiator grille).

- on the bottom side, we release the three clamping pins that secure the lower part.

- we turn the wheels to the side (it will be more convenient if the wheels are removed).

- in the wheel arches, we unscrew the screws that secure the fenders (front part).

- we pull the slats to the side and unscrew two screws on each side, which attach the sides to the brackets.

- in the inner part of the wings, approximately under the edge of the headlights, unscrew two nuts (10 mm) on each side (you will need a cap with a long collar).

- release the latches in the wings (pull the corners towards you).

- with an assistant, we pull the bumper forward (we look so as not to break the wires and hoses).

- disconnect the connectors of electrical equipment.

- disconnect the headlight washer hoses (if any, liquid may flow from the tank).

 

 

How to remove the rear bumper

- open the trunk lid.

- remove the trunk lid seal.

- lift the trunk floor covering.

- unscrew the screws and remove the rear trunk trim panel up.

- unscrew the screws, pull out the pistons and release the side panels of the trunk.

- free up space under the side panels (you need to get access to the back of the wings.

- in the inner part of the wings, we unscrew four 10 mm nuts (five nuts each, depending on the body type) on each side.

- on the bottom side, we unscrew two screws (twisted from the bottom up).

- in the wheel arches, we unscrew one screw on each side, which fasten the fenders (rear part).

- push the slats to the side and unscrew the screws that secure the sides.

- on the bottom side, we unscrew two screws (twisted from the bottom up).

- release the latches in the fenders (pull the corners of the bumper towards you).

- with an assistant, we gently pull the bumper back (we look at the wires).

- disconnect the parking sensor connectors (if any).

Audi A4 (S4) third generation B7

Production: 2004-2008

Model years 2004-2008

Body type:

4-door sedan

5-door station wagon

2-door coupe

Plastic bumpers:

A mixture of polypropylene and a triple copolymer of ethylene, propylene, diene and 20% mineral filler, marked > PP EPDM-T20<