How to remove the front bumper
- open the hood.
- under the hood, remove the plastic cover (held on the latches, take the edge and pull up).
- under the cover plate, unscrew the three screws (twisted from top to bottom. Pay attention to the different shaped screws) that secure the upper part of the front bumper.
- we unscrew the three quick-release screws that secure the engine compartment protection and the lower part.
- turn the wheels to the side.
- in the wheel arches, we screw in the screws that secure the fenders (front part).
- we pull the slats to the side and unscrew two screws on each side, which attach the sides to the brackets.
- through the wheel arches, in the inner part of the wings, we unscrew one nut on each side (you will need a long collar and a cap head).
- release the latches in the wings (pull the corners towards you).
- with an assistant, we pull off the bumper in front (we look so as not to break the wires and hoses).
- disconnect the connectors of electrical equipment.
- disconnect the headlight washer hoses (liquid may leak).
How to remove the rear bumper
- open the trunk lid.
- in the side panels of the trunk, open the covers (you need to access the wings from the inside).
- under the covers, we unscrew three nuts on each side (two in the inner part of the wings and one under the taillights. When installing, pay attention to the nuts of different shapes).
- we unscrew the three screws from the bottom side (twisted from the bottom up).
- in the wheel arches, we unscrew three screws on each side (closest to the edges), which fasten the fenders.
- release the latches in the wings (pull the corners towards you).
- with an assistant, we gently pull the bumper back (we look at the wires).
- disconnect the parking sensor connectors (the common parking sensor connector is located on the right side of the trunk in the direction of travel, behind the trim).
Audi A6 (S6) third generation C6/4F
Production 2004-2011
Body type:
4-door sedan
5-door Avant
Plastic bumpers:
A mixture of polypropylene and a triple copolymer of ethylene, propylene and diene, 20% mineral filler. Marking >PP-EPDM TV20<
Or
Polypropylene. Marking >PP <