How to remove the front bumper
- on the bottom side, we unscrew three screws (twisted from the bottom up).
- take turns turning the wheels into the inner part of the arch.
- in the wheel arches, we unscrew the screws that secure the fenders (front part).
- behind the slats, we unscrew one nut on each side for several turns, which press the corners to the brackets(it is unnecessary to unscrew completely).
- now the most difficult part, on the side of the engine compartment, we unscrew eight nuts (the location is indicated in the diagram).
- with an assistant, we remove the bumper forward from the rails in the wings (we look for wires and hoses).
- disconnect the fog lamp connectors and disconnect the headlight washer hoses.
How to remove the rear bumper
- remove the rear lights in the bumper (you need to press the tab on the back side and pull out the lamp, do not forget to disconnect the connectors and wiring harness from the brackets).
- under the lights, we unscrew two bolts (19mm, you will need a cap head).
- with the assistant, we remove the bumper back (we look so as not to break the wires).
- disconnect the electrical connectors (if any).
Land Rover Discovery Series II L318, production: 1998–2004.
Body Type: 5-door SUV
Assembling:
United Kingdom: Solihull (Solihull plant)
Jordan: Aqaba (Aqaba plant)
Malaysia: Shah Alam (AMI, SMA)
Plastic bumpers (may differ):
Polypropylene, 40% filler (fiberglass). Marking: > GM-PP-40<.