Depending on the year of manufacture, the mounting points may vary slightly.
How to remove the front bumper
- lift up the hood.
- under the hood, we pull out six clips (you need to unscrew the center screw, then pull out the clip) that attach the radiator grille.
- release the lower part of the latches (pull the bottom towards you) and remove the radiator grille.
- under the radiator grille, unscrew the two screws (twisted from top to bottom) that secure the upper part of the front bumper.
- on the bottom side, we unscrew three long bolts (note that the bolts are twisted through the bushings) and two short screws that secure the lower part.
- turn the wheels inside out.
- in the wheel arches, we unscrew two screws on each side, which fasten the fenders (front part).
- we move the fenders to the side and unscrew one screw (they will be immediately behind the fenders) and two bolts on each side (twisted from bottom to top), which attach the sides to the wings.
- on the right side, disconnect the headlight washer hoses (liquid will flow out).
- on the left side, disconnect the common connector of electrical equipment.
- release the latches in the wings (pay attention to the latches that go into the wings, they are easy to break. You need to push on the corner of the bumper, then pull down and on yourself).
- release the latches under the radiator grille.
- with the assistant we remove the bumper forward.
How to remove the rear bumper
- open the trunk lid.
- at the edges of the trunk opening, we pull out two clips.
- we remove the pads near the rear lights (they are held on latches).
- under the pads, unscrew one screw on each side and remove the taillights.
- under the taillights, unscrew two bolts (10 mm).
- remove the cover of the upper part of the bumper (held on the latches, removed up).
- under the cover plate, pull out four clips (inserted from top to bottom).
- on the bottom side, we unscrew three bolts (10 mm, twisted from the bottom up).
- unscrew the three quick-release screws (you need to turn 90°) and remove the towing hook cover.
- under the lid, unscrew two more screws.
- in the wheel arches, we unscrew four screws on each side, which fasten the linings and fenders.
- push the slats to the side and unscrew two more screws.
- we release the latches in the wings (we take the corner and pull it towards us).
- with the assistant, we remove the bumper back (we look behind the wires).
- on the left side, disconnect the two connectors of electrical equipment.
Land Rover Range Rover Velar Series 1, model code L560, production: 2017-present. Facelift 2023-present .
Body type:
5-door SUV
Assembling:
United Kingdom: Solihull (Solihull plant)
India: Pune (Jaguar Land Rover India)
Plastic bumpers (may differ):
Polypropylene plus triple copolymer of ethylene, propylene and diene, 15% mineral filler. Marking >PP+EPDM T15<