How to remove the front bumper
- open the hood.
- under the hood, we unscrew the eight TORX screws that secure the upper part of the front bumper.
- on the bottom side, we unscrew ten screws (TORX, twisted from bottom to top), which fasten the lower facings.
- depending on the side, we turn out the wheels.
- in the wheel arches, we unscrew three screws on each side (TORX), which attach the fenders (front part) and one screw on each side (twisted from bottom to top), which attach the corners to the wings.
- we release the latches above the headlights (indicated in the diagram by blue arrows, you can unscrew the four screws and remove them together with the guide profiles).
- release the latches in the wings (indicated by blue arrows on the diagram, pull the corners towards you).
- with an assistant, we remove the front bumper forward (we look so as not to break the electrical wires).
- disconnect the electrical equipment connectors (if any).
How to remove the rear bumper
- open the trunk lid.
- in the trunk opening, unscrew two screws on each side and remove the rear lights (held on the retainers in the wings).
- under the taillights, unscrew the two TORX screws that secure the upper part of the rear bumper.
- on the bottom side, unscrew the two screws and pull out the three spacer pistons that secure the lower part.
- in the wheel arches, we unscrew three screws (TORX) on each side, which fasten the fenders (rear part).
- we push the fenders to the side and unscrew one screw on each side, which fix the corners to the wings.
- release the latches in the wings (indicated in the diagram by blue arrows, pull the sides towards you).
- release the latches under the taillights.
- with an assistant, we remove the rear bumper back (we look so as not to break the wires).
- disconnect the connectors of electrical equipment.
Volkswagen ID.3 1st
Production: 2019-present
Model Years: 2020-Present
Model Code: E11/E12
Body type:
5-door hatchback
Assembling :
Germany: Zwickau (Zwickau-Moselle Factory); [4] Dresden (Transparent Factory) [5]
China: Anting ( SAIC-VW )
Plastic bumpers (may differ):
A mixture of polypropylene and ethylene / propylene, 10% mineral filler. Marking >PP+E/P-TD10<