How to remove the front bumper
- open the hood.
- under the hood, we unscrew the eight screws (twisted from top to bottom) that secure the upper part of the front bumper.
- on the bottom side, we unscrew twelve screws (twisted from the bottom up) that attach the lower part and two that attach the wheel arch extensions.
- turn the wheels to the side.
- in the wheel arches, we unscrew four screws on each side, which fasten the fenders.
- we release the front part of the wheel arch extenders (you need to put your hand between the bumper and the fender, squeeze the wheel arch expander latches with your fingers, while pulling the expanders towards you, starting from the bottom up).
- we unscrew one screw on each side, which fix the corners to the guide profiles in the wings
- release the latches above the headlights (indicated by the blue arrows on the picture, pull up).
- release the latches in the wings (indicated by the blue arrows on the picture, pull the corners towards you).
- with an assistant, we remove the front bumper forward (we look so as not to break the electrical wires).
- disconnect the connectors of electrical equipment.
\
How to remove the rear bumper
- remove the license plate along with the frame.
- under the license plate, unscrew two screws.
- open the trunk lid.
- we unscrew two screws in the trunk opening.
- on the bottom side, we unscrew six screws and pull out two spacer pistons (you need to unscrew the center screw, then pull out the spacer piston), which fasten the lower part.
- in the wheel arches, we unscrew three screws on each side, which fasten the fenders (rear part).
- we release the wheel arch extensions from the bumper (they are held on the latches, we pull them up from the bottom).
- under the wheel arch extensions, we unscrew two screws on each side.
- release the latches in the wings (marked with blue arrows in the picture, pull the corners towards you).
- release the latches under the taillights.
- with an assistant, we remove the rear bumper back (we look so as not to break the wires).
- disconnect the connectors of electrical equipment.
Volkswagen ID.4 / ID.5
Production: 2020-present
Model code: E21 (ID. 4) / E39 (ID. 5)
Body type:
5-door SUV (ID. 4)
5-door SUV coupe (ID. 5)
Assembling :
Germany: Zwickau (Zwickau-Moselle Plant); Emden
USA: Chattanooga, Tennessee (Chattanooga Assembly Plant )
China: Anting (SAIC-VW, ID. 4 X); Foshan ( FAW-VW, ID. 4 Crozz)
Plastic bumpers (may differ):
A mixture of polypropylene and ethylene / propylene, 10% mineral filler. Marking >PP+E/P-TD10<