Depending on the year of manufacture, the mounting points differ. For the second facelift (2010-2015), see the separate instructions in the catalog.
How to remove the front bumper
- open the hood.
- under the hood, unscrew the two screws (twisted from top to bottom) that secure the radiator grille. (2006-2010) unscrew the two screws at the bottom of the grid.
- we release the radiator grille from the latches and remove it.
- under the radiator grille:
(2003-2006) we unscrew the two screws (twisted from top to bottom) that secure the upper part of the front bumper.
(2006-2010) unscrew one screw (it may not be, it is twisted from top to bottom) and release two latches (you need to press the tab with a flat screwdriver and pull it towards you).
- in the lower grate, unscrew two screws (since 2006, instead of latch screws, you need a long flat screwdriver to release them).
- on the bottom side, we unscrew eight screws (twisted from the bottom up).
- we turn the wheels into the inner part of the arch.
- in the wheel arches, we unscrew four (three) screws on each side, which fasten the fenders (front part).
- we unscrew one screw on each side (twisted from bottom to top), which fix the corners to the guide profiles in the wings.
- we release the latches in the wings (2003-2006 we move the sides forward and pull towards ourselves, 2006-2010 we pull the corners towards ourselves).
- with an assistant, we remove the front bumper forward (we look so as not to break the wires and hoses).
- disconnect the connectors of electrical equipment, (if any) pull out the temperature sensor.
- disconnect the headlight washer hoses from the tank (please note that liquid will leak out).
How to remove the rear bumper
- open the trunk lid.
- remove the plastic linings near the rear lights (they are held on latches).
- under the pads, we unscrew two screws on each side and remove the taillights (they are held on the retainers in the wings, you need to move them to the outer sides from the trunk opening).
- under the taillights, we unscrew two screws on each side that secure the upper part of the rear bumper.
- on the bottom side, we unscrew the four screws (twisted from bottom to top) that secure the lower part.
- (if any) in the wheel arches, unscrew the screws and remove the mudguards.
- we unscrew three screws on each side, which fasten the fenders (rear part).
- we pull out one piston on each side, which fasten the corners to the wings.
- with an assistant, we remove the bumper back from the guide profiles in the wings (we look so as not to damage the wires).
- disconnect the connectors of electrical equipment (if any).
Volkswagen Touran Mk1, type 1T
Other designations: Volkswagen Golf Touran (Japan)
Production: 2003-2015, first facelift 2006-2010, second facelift 2010-2015 (see separate instructions in the catalog)
Assembling:
Germany: Wolfsburg
China: Anting (SAIC-VW)
Indonesia: Jakarta
Body type:
5-door minivan
Plastic bumpers (may differ):
Polypropylene plus triple copolymer of ethylene, propylene and diene, 10% mineral filler. Marking >PP+EPDM-T10< (>PP+EPDM-TD10<)