Depending on the year of manufacture, the mounting points differ slightly.
How to remove the front bumper
- open the hood.
- under the hood, unscrew two screws and pull out seven pistons (first you need to push the center pin inside, then remove the piston up).
- on the bottom side, we unscrew eight screws (twisted from the bottom up), which attach the lower part to the bottom lining (if you need to remove the bumper along with the lining, then unscrew the far screws).
- in the wheel arches, we unscrew four screws on each side, which fasten the fenders (the front part, it will be more convenient if you turn the wheels).
- release the latches that attach the sides to the plastic brackets in the wings (pull the corners towards you).
- with the assistant, we remove the bumper forward (carefully, do not break the wires. Please note that the wiring harness is attached with pistons to the bottom lining).
- disconnect the connectors of electrical equipment.
- if the headlight washers are installed, then disconnect the hoses.
How to remove the rear bumper
- open the trunk lid.
- (Volvo V60 MK1) in the trunk opening, remove the thrust elements of the lid (you need to turn it counterclockwise and pull it towards you).
- we unscrew two screws from the bottom side (twisted from the bottom up).
- in the wheel arches, we unscrew five screws on each side (in order not to remove the wheels, you will need a ratchet with a TORX bat).
- release the latches in the wings (pull the corners towards you).
- release the latches under the taillights.
- with the assistant, we remove the bumper back (be careful not to break the wires).
- disconnect the connectors of electrical equipment (usually a common connector on the right side).
Volvo S60 MK2, production 2010-2018, restyled 2013-2018.
Volvo V60 MK1, production 2010-2018, restyled 2013-2018.
Assembling:
Sweden: Torslanda (Torslandaverken)
Belgium: Ghent (VCG)
Malaysia: Shah Alam (VCMM)
China: Chengdu (ZAMC)
Body type:
4-door sedan (S60)
5-door station wagon (V60)
Plastic bumpers (may differ):
Polypropylene plus triple copolymer of ethylene, propylene and diene, 20% mineral filler. Marking >PP+EPDM-TD20<