Depending on the year of manufacture, the mounting points may vary slightly.
How to remove the front bumper
- open the hood.
- under the hood, pull out the four clips (inserted from top to bottom) that secure the radiator grille.
- remove the radiator grille (take it by the bottom of the grille and pull it towards you. Pay attention to the rubber seal).
- under the radiator grille, we pull out four pistons (inserted from top to bottom), which attach the upper part of the front bumper.
- on the bottom side, unscrew the two screws and remove the towing hook cover (pull forward).
- under the lid, unscrew three screws and pull out two clips.
- we turn the wheels in turn to the inside of the arch.
- we release the front part of the wheel arch extensions (they are held on latches, you need to pry and pull on yourself).
- we unscrew two screws from the bottom side, pull out one clip under the wheel arch extensions, unscrew two plastic nuts and remove the front half of the fenders.
- behind the fenders, we unscrew two screws and pull out one clip on each side, which fasten the sides to the wings (it is difficult to pull out the whole clip, it usually breaks).
- behind the fender cover on the left side, we release the connectors for the fog lights and parking assistant.
- on the right side, disconnect the hoses of the headlight washing system (attention, liquid will flow out).
- with the assistant we remove the bumper forward.
How to remove the rear bumper
- open the trunk lid.
- near the taillights, remove the plugs and unscrew two screws on each side under them (the lower two screws attach the upper part of the rear bumper through the taillights).
- we release the retainers in the wings and remove the taillights.
- in the trunk opening, pull out two clips.
- on the bottom side, we unscrew the four upper bolts (10 mm) that secure the bumper through the aluminum reflector.
- in the wheel arches, we unscrew two screws each and pull out one clip each.
- we release the wheel arch extensions from the bumper (they are held on two latches each, you need to pull on yourself.
- we release the latches in the wings (we take the corner and pull it towards us).
- with the assistant, we remove the bumper back (we look behind the wires).
- disconnect the connectors of electrical equipment.
Land Rover Range Rover Evoque Series 1, model code L538, production: 2011–2018. Restyling 2015-2018.
Body type:
3/5-door SUV
2-door convertible suv
Assembling:
United Kingdom: Halewood
China: Changshu (Chery Jaguar Land Rover)
India: Pune (Jaguar Land Rover India)
Plastic bumpers (may differ):
A mixture of polypropylene and ethylene / propylene, 15% filler. Marking >PP+E/P+TD15<