How to remove the front bumper
- open the hood.
- under the hood, we unscrew two screws and pull out two thrust pistons (for removal, in the side part of the piston, there is a slot for a flat screwdriver), which fasten the front part of the bumper and the radiator grille.
- on the bottom side, we unscrew eleven bolts (10 mm, twisted from bottom to top), which fasten the lower part.
- turn the wheels to the side.
- (on the left and right sides) in the wheel arch, we remove three pistons that attach the fender (front part).
- (on the left and right sides) move the fender cover to the side and unscrew the screw (8 mm, twisted from bottom to top), which fix the corner to the wing.
- we release the sides from the latches in the brackets (we take the corner and pull it towards us).
- with an assistant, we remove the front bumper forward (we look so as not to break the wires and hoses).
- release the fog lamp connectors (if any).
- if the front optics washer nozzles are installed, disconnect the hoses (liquid will flow out).
How to remove the rear bumper
- open the trunk lid.
- in the trunk opening, unscrew the two screws that secure the upper part of the rear bumper.
- on the bottom side, unscrew the two screws and pull out the two clips (twisted and inserted from the bottom up) that secure the lower part.
- in the wheel arches, we unscrew the screws that secure the fenders.
- we take the fenders to the side and unscrew one screw on each side (twisted from the bottom up, which fix the corners to the wings.
- release the latches in the wings (pull the corners towards you).
- release the four pins that go into the bushings in the rear panel of the trunk (marked on the diagram with blue arrows, you just need to pull on yourself).
- with the assistant, we remove the bumper back (we look behind the wires).
- disconnect the electrical equipment connectors (if installed).
Mazda 5 MK1. Model code CR. Production: (2005-2010)
Also called Mazda Premacy
Body type: 5-door minivan
Assembling:
Japan: Hiroshima (Hiroshima Plant)
Taiwan: Zhongli (Ford Lio Ho)
Plastic bumpers:
Polypropylene plus filler. Marking >PP-(S27-T17)<